The Most Common Types of Plumbing Valve You Will Found Everywhere

Publish Time: Author: Site Editor Visit: 762

Whether its home or industry, the plumbing system exist everywhere as it follows by the use of water, wherever there would be a gigantic use of water, you will need a plumbing system to run a certain, and controlled operation for it, even if it exists in any ship or any commercial place.

There are a variety of plumbing valves which are found at various points along the water pipes that allow you to turn off or ON an access of water during emergencies, or when you need to make repair or upgrades.

Shutting off water is primarily the initial step in many industries as well as plumbing projects. Locating and turning off appropriate water shut off hence becomes very important. Though there is no shortage of valve suppliers in the industrial market today, yet the thirst of approaching an ultimate one always stay an open priority.

However, do you know what the most common types of plumbing valves which are widely used in industrial and plumbing projects are? Listed below are the common types of plumbing valves

Ball Valve A ball valve is normally a large metal valve which usually features a lever handle, it is designed for a quick turn off since the valve opens and closes full with a short turn of the lever handle.

Gate valve A gate valve describes the mechanism by which the valve is opened and close. For turning gate valve on or off, a circular handle is turned to raise or lowers a metal gate inside the valve body. The gate blocks the flow of water when valve is off.

Globe Valve Superficially, globe valves look like a ball valve with a slightly bulbous metal body. Anyhow, unlike a ball valve, a globe valve is designed to allow variable adjustment of water flow. There is a baffle with a water flow port inside the valve which runs through it.

The handle operates a plunger with some kind of washer or seal on the bottom; as the handle closes the valve, the plunger moves down against the water flow port and partially closes it off.

Angled Fixture Shut off valve The individual fixtures should have some form in individual shut-off valves that control water to only those fixtures. This allows water to be shut off for small repairs or replacement to the fixtures itself without interrupting water flow to other areas. These fixture shut-off valves can take many appearances, yet the most common one is; small silver colored valve with an oval handle with ribbed edges for gripping.

Straight fixture shut off valves It can be said to be a sister valve of an angled fixture shut-off. It is a straight shut off which operates just like angled shut off does, but it is intended for use where water flow can run straight to the fixture.

Its also widely used where a water pipe comes up out of the floor rather than out from the valve.